![]() Fixed TXTEXP crash progecad selecting all drawing. Install the latest versions and updates available for Civil 3D, AutoCAD and Map 3D. ![]() View using command -VIEW (W option) like autocad and progecad 2011. See: Where to download products and updates. In particular, the AutoCAD 2022.1 and Civil 3D 2022.1 updates include numerous performance improvements.Reset the application to defaults: How to reset Civil 3D to defaults. Since the power pole block was created on layer 0, but placed on layer PWP, selecting the block to Freeze does not freeze PWP - it freezes 0, along with every other block in my drawing.See: How to perform a clean uninstall of Civil 3D. Go to Options -> System tab, under Layout Regen Options and select Cache model tab and all layouts, click Apply and OK or set the LAYOUTREGENCTL to 2. Make sure you are using a supported network configuration.This option regenerates the drawing the first time you switch to each tab, the display list is saved and regeneration is suppress when going back and forward between them I hope this tip helps. If Civil 3D hangs when opening a specific drawing file More details in: Autodesk Support for Non-Microsoft Networks. See: How to repair Civil 3D drawing which shows bad behavior. Check and optimize the graphics driver settings.When we were using Civil 3D 2010 (32-bit) we noticed that the new modeless layer manager window was causing serious delay in regeneration.Update the graphics driver (see How to update to the latest certified video driver). Be sure to update all graphics drivers for discrete and integrated cards. Check if the software is using the high-end graphics card (see How to configure Autodesk software to use high-performance graphics). It seems that you are experiencing similar issues. Disable graphical hardware acceleration within the software (see How to enable or disable hardware acceleration in AutoCAD).How, I can tell you that in Civil 3D 2011 (64-bit) does not display the same quirk.
0 Comments
Leave a Reply. |